Special Coverage Series

Network Computing

Special Coverage Series

Commentary

Howard Marks
Howard Marks Network Computing Blogger

Dell, HP Erode Startups' Advantages in Flash Storage

Startups with purpose-built flash arrays had an advantage over incumbent storage vendors that retrofit SSDs into systems designed for spinning disk. That advantage is disappearing.

In the past I was of the opinion that storage systems purpose-built for flash were inherently superior to storage systems that took an existing architecture and replaced the spinning disks with SSDs. However, a few big-name storage vendors are using traditional arrays to build all-flash (or as they prefer to call them, flash-optimized) systems. These systems are landing in the same price/performance ballpark as new flash arrays from upstarts such Pure Storage, Whiptail and Violin Memory.

Early examples of flash conversion among incumbents were not impressive. The EMC VNX 5500-F and HP Lefthand P4900 were so hamstrung by their underlying architectures that few storage analysts viewed them as serious alternatives to the shiny new systems from startups.

More Insights

Webcasts

More >>

White Papers

More >>

Reports

More >>

These early attempts were either IOP-limited or overly expensive (or both), in part because the traditional RAID logic their ancestor systems used for data protection on disk drives created a lot of write amplification. This amplification forced the designers to exclusively use expensive SLC SSDs.

However, recent product announcements by Dell and HP, and a lengthy conversation at Dell's Enterprise Forum, have me thinking that some disk-based systems make the transition well enough to make them contenders with purpose-built arrays.

One reason is the new Dell/Compellent and HP/3Par systems are based on architectures that are only about 10 years old. This is important, because it means they never used traditional RAID to protect data spindle by spindle but instead used "chunklet RAID," which is much better suited to both the requirements of flash and data movement.

However, my first reaction to Dell Compellent's flash-optimized system announcement was, "Really? Isn't the SLC era over?" This was an opinion echoed by my fellow analysts. That's because, in general, the flash controller folks have made MLC a much better storage medium that it was a few years ago, even though the smaller-geometry MLC chips, other than being cheaper per gigabyte, are actually worse.

Yet on closer inspection, the SLC/MLC hybrid architecture that Dell is pitching makes a lot of sense. In fact I've proposed a similar architecture for an enterprise SSD of the future. Incoming data is written to the SLC SSDs, which are faster on writes and have much greater write endurance. When the data in the SLC layer exceeds some high-water mark, the data progression process is triggered, moving the cooler chunks down to MLC.

Because Compellent's data progression was the first implementation of sub-LUN tiering, Dell Compellent is fond of the process. I generally prefer caching, but the progression process seems a better fit here than in most other cases.

Any really hot data, like the inventory record for popular items during the Christmas rush, will stay in SLC and absorb all the write traffic. This lets Dell use MLC SSDs that are "read optimized," which mostly means that they have lower levels of overprovisioning than typical enterprise MLC drives, thus keeping costs down. In fact, Dell claims the flash-optimized system has a cost-per-gigabyte price comparable to 15K RPM disk systems. By contrast, startups use data reduction to master this trick.

The key advantage the incumbents have is the wealth of storage management available for a platform that's been in a thousand customer sites for years. Not only do the latest flash-optimized Dell Compellents and 3Pars have all the snapshots, replication and host integration features their disk-based systems do, they also have the kind of third-party storage resource management software support that Pure Storage, Whiptail and Violin Memory can only dream of.

If we compare systems announced in the past month or so, Pure Storage's latest update has boosted its performance to 400,000 IOPS.

By comparison, the latest system from Dell Compellent tops out at 300,000 IOPS, while HP's four-controller 3Par 7450 hits 500,000, with latency under 1ms. Pure Storage manages all that performance with deduplication while the mainstream players are still storing straight data, but I'm adding the latest Dell Compellent and 3Par systems to my all-solid-state options list. Perhaps you should, too.

Disclaimer: Dell and HP have both been clients of DeepStorage, LLC over the years, as have some of the startups.



Related Reading



Network Computing encourages readers to engage in spirited, healthy debate, including taking us to task. However, Network Computing moderates all comments posted to our site, and reserves the right to modify or remove any content that it determines to be derogatory, offensive, inflammatory, vulgar, irrelevant/off-topic, racist or obvious marketing/SPAM. Network Computing further reserves the right to disable the profile of any commenter participating in said activities.

 
Disqus Tips To upload an avatar photo, first complete your Disqus profile. | Please read our commenting policy.
 

Editor's Choice

Research: 2014 State of Server Technology

Research: 2014 State of Server Technology

Buying power and influence are rapidly shifting to service providers. Where does that leave enterprise IT? Not at the cutting edge, thatís for sure: Only 19% are increasing both the number and capability of servers, budgets are level or down for 60% and just 12% are using new micro technology.
Get full survey results now! »

Vendor Turf Wars

Vendor Turf Wars

The enterprise tech market used to be an orderly place, where vendors had clearly defined markets. No more. Driven both by increasing complexity and Wall Street demands for growth, big vendors are duking it out for primacy -- and refusing to work together for IT's benefit. Must we now pick a side, or is neutrality an option?
Get the Digital Issue »

WEBCAST: Software Defined Networking (SDN) First Steps

WEBCAST: Software Defined Networking (SDN) First Steps


Software defined networking encompasses several emerging technologies that bring programmable interfaces to data center networks and promise to make networks more observable and automated, as well as better suited to the specific needs of large virtualized data centers. Attend this webcast to learn the overall concept of SDN and its benefits, describe the different conceptual approaches to SDN, and examine the various technologies, both proprietary and open source, that are emerging.
Register Today »

Related Content

From Our Sponsor

How Data Center Infrastructure Management Software Improves Planning and Cuts Operational Cost

How Data Center Infrastructure Management Software Improves Planning and Cuts Operational Cost

Business executives are challenging their IT staffs to convert data centers from cost centers into producers of business value. Data centers can make a significant impact to the bottom line by enabling the business to respond more quickly to market demands. This paper demonstrates, through a series of examples, how data center infrastructure management software tools can simplify operational processes, cut costs, and speed up information delivery.

Impact of Hot and Cold Aisle Containment on Data Center Temperature and Efficiency

Impact of Hot and Cold Aisle Containment on Data Center Temperature and Efficiency

Both hot-air and cold-air containment can improve the predictability and efficiency of traditional data center cooling systems. While both approaches minimize the mixing of hot and cold air, there are practical differences in implementation and operation that have significant consequences on work environment conditions, PUE, and economizer mode hours. The choice of hot-aisle containment over cold-aisle containment can save 43% in annual cooling system energy cost, corresponding to a 15% reduction in annualized PUE. This paper examines both methodologies and highlights the reasons why hot-aisle containment emerges as the preferred best practice for new data centers.

Monitoring Physical Threats in the Data Center

Monitoring Physical Threats in the Data Center

Traditional methodologies for monitoring the data center environment are no longer sufficient. With technologies such as blade servers driving up cooling demands and regulations such as Sarbanes-Oxley driving up data security requirements, the physical environment in the data center must be watched more closely. While well understood protocols exist for monitoring physical devices such as UPS systems, computer room air conditioners, and fire suppression systems, there is a class of distributed monitoring points that is often ignored. This paper describes this class of threats, suggests approaches to deploying monitoring devices, and provides best practices in leveraging the collected data to reduce downtime.

Cooling Strategies for Ultra-High Density Racks and Blade Servers

Cooling Strategies for Ultra-High Density Racks and Blade Servers

Rack power of 10 kW per rack or more can result from the deployment of high density information technology equipment such as blade servers. This creates difficult cooling challenges in a data center environment where the industry average rack power consumption is under 2 kW. Five strategies for deploying ultra-high power racks are described, covering practical solutions for both new and existing data centers.

Power and Cooling Capacity Management for Data Centers

Power and Cooling Capacity Management for Data Centers

High density IT equipment stresses the power density capability of modern data centers. Installation and unmanaged proliferation of this equipment can lead to unexpected problems with power and cooling infrastructure including overheating, overloads, and loss of redundancy. The ability to measure and predict power and cooling capability at the rack enclosure level is required to ensure predictable performance and optimize use of the physical infrastructure resource. This paper describes the principles for achieving power and cooling capacity management.