Network Computing is part of the Informa Tech Division of Informa PLC

This site is operated by a business or businesses owned by Informa PLC and all copyright resides with them. Informa PLC's registered office is 5 Howick Place, London SW1P 1WG. Registered in England and Wales. Number 8860726.

How to Define an IP Range With Wireshark

Wireshark logo on computer chip background.
Borka Kiss / Alamy Stock Photo

One of the keys to being an effective network troubleshooter when using a protocol analyzer is the ability to see patterns, which is where filters come into play. In this video, I review the two most common filters in Wireshark. Note that in Wireshark, display and capture filter syntax are completely different. A capture filter is configured prior to starting your capture and affects what packets are captured. A display filter is configured after you have captured your packets.

You may not know what to focus on when you capture packets, resulting in no capture filter. Even when you have a capture filter, it may be too generic. In either case, you will need to use a display filter to narrow the traffic down.

In this video, I respond to a question from one of my readers who wanted to create a Wireshark display filter for many IP addresses. One time-consuming approach would be to literally type out all the addresses you want to filter by. However, if the addresses are contiguous or in the same subnet, you might be able to get away with a Wireshark subnet filter.

The display filter syntax to filter out addresses between 192.168.1.1 – 192.168.1.255 would be ip.addr==192.168.1.0/24 and if you are comfortable with IP subnetting, you can alter the /24 to change the range.