Special Coverage Series

Network Computing

Special Coverage Series

Commentary

Greg  Ferro

SDN Doesn't Mean Cheaper Networking

The most common prediction about SDN is that networking will get cheaper. It won't. Here's why.

The most common prediction about SDN is that networking will get cheaper. In fact, IT will spend the same as it always has on networking, but the money will be allocated in different ways. Meanwhile, market pressures will force traditional vendors such as Cisco to adopt new revenue models.

Let's start with network hardware. I predict network hardware will get cheaper because it must be replaced and upgraded more often in the years ahead.

More Insights

Webcasts

More >>

White Papers

More >>

Reports

More >>

Today, a network device has a lifespan of at least five years; in many cases, it may be up to 10 years before it is considered for replacement. However, technology developments will speed up hardware refreshes; the next generation of networking is likely to be replaced every three years as the drive into 10-GbE ports will soon be followed by 40-GbE and 100-GbE interfaces.

We'll also see new silicon with lower power consumption, support for overlay networking and increased forwarding performance compel faster product churn.

It's reasonable to expect unit prices to fall as customers rapidly cycle out network assets in the same way that server assets are removed to gain new features or functions. However, while unit prices drop, overall network spending will remain the same because of the need to replace hardware more often.

[Network overlays virtualize the network for SDN. Get details in "Network Overlays: An Introduction."]

Another way hardware costs could be lowered is by changing vendor practices around expensive optical and copper interface modules. A significant percentage (often more than 50% ) of the standing cost of network devices is largely due to these modules, which deliver little customer value. The future of networking is services, not connectivity.

It's not necessary for "vendor supported" SFP modules to cost in excess of $300 per unit--even less so to enforce this in software. If the standard is badly written that there are reliability or production problems, then vendors should kick the IEEE into action to produce better standards that are resistant to low-quality manufacturing and prevent unreliable manufacturers from making poor copies.

It is beyond the scope of this article to explain the foolish choices made by the IEEE during the standards process that have resulted in extortionate pricing for what could be low-cost items.

SDN could get cheaper if there was a concerted effort from vendors and customers to drive new standards with reasonable technology choices for cheaper interface modules. Shipping SFP modules adds zero value to customer features or functions and customers resent paying for them.

Off-Brands Won't Flourish

Some make the argument that unbranded hardware will erode the market for premium-priced equipment. I don't think so. There's a lot of inexpensive networking equipment available today from vendors like Netgear and D-Link, including low-cost chassis switches. Yet the majority of customer continue to buy branded hardware for quality and assurance reasons.

Why would SDN change this purchasing practice ? The underlying reasons for purchasing branded or known hardware--customers want a trusted brand and partner in their data centers--aren't changed by SDN.

Niche use cases from mega-scale data centers simply aren't relevant to enterprises or service providers. Google and Facebook purchase low-cost network equipment direct from the manufacturer, but they also perform extensive testing to prove the hardware is viable and fit for purpose.

There is identifiable risk that low-cost products may have higher failure rates, poor quality software or other serious operational issues. While the mega-scale companies have software platforms designed to handle failure easily, enterprises are not experienced in handling these kinds of risks.

Cheaper, Simpler Software

The price of the network OS on the device is also likely to fall in the years ahead. Today, customers purchase a license for an integrated NOS that runs on the specific device. These NOSes often have thousands of features, functions and services that ultimately deliver network services.

However, a key value of current SDN platforms such as VMware NSX is that network services will be provided in a hypervisor or in a virtual machine.

Two factors should lead to lower prices. First, a software license today comes with the device that is intended to be used for at least five years. This timeline is factored into the customer value proposition (that is, the purchase price). As customers rotate hardware faster, the software license has less value over the life of the device, which will lead to price pressures on suppliers.

Second, market competition for cheaper NOSes is being introduced by startups. For instance, Cumulus Networks and Big Switch Networks have introduced NOSes that operate independent of the network hardware. ODM suppliers are already shipping small numbers of network switches that support these open NOS environments.

These startups license their software on a recurrent revenue model, and any purchase has a serious impact on the short-term revenue of incumbent vendors. This should drive lower prices on existing equipment.

As stated earlier, rapid device rotation is likely to occur, so software costs must go down to match perceived and/or delivered product value. Product rotation is needed to support greater bandwidth, faster forwarding performance and increased density.

Next Page: SDN Platforms Add Up

 1 | 2  | Next Page »


Related Reading



Network Computing encourages readers to engage in spirited, healthy debate, including taking us to task. However, Network Computing moderates all comments posted to our site, and reserves the right to modify or remove any content that it determines to be derogatory, offensive, inflammatory, vulgar, irrelevant/off-topic, racist or obvious marketing/SPAM. Network Computing further reserves the right to disable the profile of any commenter participating in said activities.

 
Disqus Tips To upload an avatar photo, first complete your Disqus profile. | Please read our commenting policy.
 

Editor's Choice

Research: 2014 State of Server Technology

Research: 2014 State of Server Technology

Buying power and influence are rapidly shifting to service providers. Where does that leave enterprise IT? Not at the cutting edge, thatís for sure: Only 19% are increasing both the number and capability of servers, budgets are level or down for 60% and just 12% are using new micro technology.
Get full survey results now! »

Vendor Turf Wars

Vendor Turf Wars

The enterprise tech market used to be an orderly place, where vendors had clearly defined markets. No more. Driven both by increasing complexity and Wall Street demands for growth, big vendors are duking it out for primacy -- and refusing to work together for IT's benefit. Must we now pick a side, or is neutrality an option?
Get the Digital Issue »

WEBCAST: Software Defined Networking (SDN) First Steps

WEBCAST: Software Defined Networking (SDN) First Steps


Software defined networking encompasses several emerging technologies that bring programmable interfaces to data center networks and promise to make networks more observable and automated, as well as better suited to the specific needs of large virtualized data centers. Attend this webcast to learn the overall concept of SDN and its benefits, describe the different conceptual approaches to SDN, and examine the various technologies, both proprietary and open source, that are emerging.
Register Today »

Related Content

From Our Sponsor

How Data Center Infrastructure Management Software Improves Planning and Cuts Operational Cost

How Data Center Infrastructure Management Software Improves Planning and Cuts Operational Cost

Business executives are challenging their IT staffs to convert data centers from cost centers into producers of business value. Data centers can make a significant impact to the bottom line by enabling the business to respond more quickly to market demands. This paper demonstrates, through a series of examples, how data center infrastructure management software tools can simplify operational processes, cut costs, and speed up information delivery.

Impact of Hot and Cold Aisle Containment on Data Center Temperature and Efficiency

Impact of Hot and Cold Aisle Containment on Data Center Temperature and Efficiency

Both hot-air and cold-air containment can improve the predictability and efficiency of traditional data center cooling systems. While both approaches minimize the mixing of hot and cold air, there are practical differences in implementation and operation that have significant consequences on work environment conditions, PUE, and economizer mode hours. The choice of hot-aisle containment over cold-aisle containment can save 43% in annual cooling system energy cost, corresponding to a 15% reduction in annualized PUE. This paper examines both methodologies and highlights the reasons why hot-aisle containment emerges as the preferred best practice for new data centers.

Monitoring Physical Threats in the Data Center

Monitoring Physical Threats in the Data Center

Traditional methodologies for monitoring the data center environment are no longer sufficient. With technologies such as blade servers driving up cooling demands and regulations such as Sarbanes-Oxley driving up data security requirements, the physical environment in the data center must be watched more closely. While well understood protocols exist for monitoring physical devices such as UPS systems, computer room air conditioners, and fire suppression systems, there is a class of distributed monitoring points that is often ignored. This paper describes this class of threats, suggests approaches to deploying monitoring devices, and provides best practices in leveraging the collected data to reduce downtime.

Cooling Strategies for Ultra-High Density Racks and Blade Servers

Cooling Strategies for Ultra-High Density Racks and Blade Servers

Rack power of 10 kW per rack or more can result from the deployment of high density information technology equipment such as blade servers. This creates difficult cooling challenges in a data center environment where the industry average rack power consumption is under 2 kW. Five strategies for deploying ultra-high power racks are described, covering practical solutions for both new and existing data centers.

Power and Cooling Capacity Management for Data Centers

Power and Cooling Capacity Management for Data Centers

High density IT equipment stresses the power density capability of modern data centers. Installation and unmanaged proliferation of this equipment can lead to unexpected problems with power and cooling infrastructure including overheating, overloads, and loss of redundancy. The ability to measure and predict power and cooling capability at the rack enclosure level is required to ensure predictable performance and optimize use of the physical infrastructure resource. This paper describes the principles for achieving power and cooling capacity management.