Variable usage ITO pricing cost is driven by both the data center pricing schedule unit cost and resource usage. The most common practice is to negotiate rates based on baseline resource assumptions and then adjust--up or down--each month based on actual consumption. In practice, limits on variance exist, with unit costs increasing at lower volumes and discounts applied for increased volumes. Of course, other charges and credits come into play, as well.
While this pay-per-use model is intuitively appealing, without diligent asset and vendor management, financial creep is a challenge in this billing approach. In fact, mid-term outsourcing relationship audits (for example, in year three of a five- to seven-year contract) have shown that many ITO clients are running at 20% to 30% over growth-corrected total spend expectations. It is critical to take the following preventive measures to proactively manage pricing overages and drive positive vendor behavior regarding resource efficiency.
1. Don’t reward resource "sprawl": The obvious downside of variable pricing contracts based on resource units is that they motivate the service provider to add resource units. In a perfect world, resources would be responsibly managed to competitive utilization targets. In practice, however, we see clients paying for idle and underutilized resources on a regular basis. Real-world examples include a client paying for backup resources (automated tape library slots) that were 9% in use, a server environment that was so poorly tuned it was incurring 30% overhead (net additional hardware) and a number of clients paying for storage capacity at less than 40% utilization. For outsourcing contracts with client-owned hardware and software, consider the service provider’s dilemma: Make unreimbursed investments in technology and tuning efforts to increase efficiency and drive down your revenue stream, or maintain the status quo and watch revenue grow with increased overhead. Although most contracts typically include some shared savings incentives and continuous improvement responsibilities, the contract language is often not specific enough to enforce.
To effectively manage the disconnect between service provider revenue generation and efficient asset utilization, end users should consider one or more of the following approaches to get the client-vendor relationship on track from the start
a.) Define billable resource units to align with real usage, not raw capacity.
In this approach, resource units are defined to reflect consumption, not capacity. As an example, the vendor charges only for allocated storage (the storage a server can "see" looking out from its I/O interfaces), not the available capacity of the installed storage array. While some per-unit rates may be higher, if scaled correctly, it is well worth the trade-off. For example, if a service provider is prepared to charge $100/terabyte/month for installed capacity and assumes it can get an effective yield of 60% for client-usable storage, it will seek a "usable capacity" rate of $100/60%=$167/terabyte/month. Going forward, the vendor will have to manage to 60% utilization to maintain initial profit margins. Were effective utilization to drop over time due to poor management, it would be at vendor expense, not client expense. The logic supporting this storage-based example extends to server utilization via exploitation of virtualization and standardization, network resource utilization, and so on.
b.) Define minimum utilization standards for all resource categories.
Here the contract will contain very specific resource utilization and efficiency metrics with penalties for underutilization, or billing relief for missed targets. Be very specific in defining not only what the utilization targets are, but also the specific tools and methods used to measure them. They should be measured on a regular basis--monthly is ideal.
c.) Retain architectural control and ownership of the resource definition and placement process.
In this very simple and direct approach, additions to resource pools are at the client’s discretion. The statement of work (that is, the description of services) contract exhibit specifies that retained client technical resources have the final word on when new resources are created, how they are defined and where they are placed. However, be aware that without control over resource utilization and resource placement, service providers may limit their accountability for service levels around performance and, to a lesser extent, availability.